1 /*        $NetBSD: edcreg.h,v 1.5 2008/05/04 13:11:14 martin Exp $    */
2 
3 /*
4  * Copyright (c) 2001 The NetBSD Foundation, Inc.
5  * All rights reserved.
6  *
7  * This code is derived from software contributed to The NetBSD Foundation
8  * by Jaromir Dolecek.
9  *
10  * Redistribution and use in source and binary forms, with or without
11  * modification, are permitted provided that the following conditions
12  * are met:
13  * 1. Redistributions of source code must retain the above copyright
14  *    notice, this list of conditions and the following disclaimer.
15  * 2. Redistributions in binary form must reproduce the above copyright
16  *    notice, this list of conditions and the following disclaimer in the
17  *    documentation and/or other materials provided with the distribution.
18  *
19  * THIS SOFTWARE IS PROVIDED BY THE NETBSD FOUNDATION, INC. AND CONTRIBUTORS
20  * ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED
21  * TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
22  * PURPOSE ARE DISCLAIMED.  IN NO EVENT SHALL THE FOUNDATION OR CONTRIBUTORS
23  * BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR
24  * CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
25  * SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
26  * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
27  * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
28  * ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
29  * POSSIBILITY OF SUCH DAMAGE.
30  */
31 
32 /*
33  * Driver for MCA ESDI controllers and disks.
34  */
35 
36 #define   ESDIC_IOPRM                   0x3510
37 #define ESDIC_IOALT           0x3518
38 #define ESDIC_REG_NPORTS      8
39 #define ESDIC_IRQ             14                  /* this is fixed */
40 
41 /* pos2 */
42 #define IO_IS_ALT             0x02
43 #define DRQ_MASK              0x3c
44 #define   FAIRNESS_ENABLE               0x40
45 
46 /* pos3 */
47 #define PACING_INT_MASK                 0x30
48 
49 /* pos4 */
50 #define   PACING_CTRL_DISABLE 0x01
51 #define RELEASE_2             0x02      /* lower bit of Time to Release */
52 #define RELEASE_1             0x04      /* higher bit of Time to Release */
53 
54 /* controller registers */
55 #define SIFR                            0         /* read Status Interface Register,
56                                                      2 bytes, little endian */
57 #define SIFR_CMD_MASK                   0x2f
58 
59 #define CIFR                            0         /* write - Command Interface Reg,
60                                                      2 bytes, little endian */
61 #define CIFR_LONG_CMD                   (1<<14) /* 4 word command */
62 
63 /* Command Codes */
64 #define CMD_READ_DATA                   0x01      /* uses DMA */
65 #define CMD_WRITE_DATA                  0x02      /* uses DMA */
66 #define CMD_READ_VERIFY                 0x03
67 #define CMD_WRITE_VERIFY      0x04      /* uses DMA */
68 #define CMD_SEEK              0x05
69 #define CMD_PARK_HEAD                   0x06
70 #define CMD_GET_CMD_COMP_STATUS         0x07
71 #define CMD_GET_DEV_STATUS    0x08
72 #define CMD_GET_DEV_CONF      0x09
73 #define CMD_GET_POS_INFO      0x0A
74 #define CMD_TRANSLATE_RBA     0x0B
75 #define CMD_WRITE_ATTACH_BUFF 0x10      /* uses DMA */
76 #define CMD_READ_ATTACH_BUFF  0x11      /* uses DMA */
77 #define CMD_RUN_DIAG_TEST     0x12
78 #define CMD_GET_DIAG_STAT_BLOCK         0x14
79 #define CMD_GET_MFG_HEADER    0x15      /* uses DMA */
80 #define CMD_FORMAT_UNIT                 0x16      /* uses DMA */
81 #define CMD_FORMAT_PREPARE    0x17
82 #define   CMD_SET_MAX_RBA               0x1A
83 #define CMD_SET_PWR_SAV_MODE  0x1B      /* optional */
84 #define CMD_POWER_CONS_CMD    0x1C      /* optional */
85 
86 #define BCR                             2         /* write */
87 #define BCR_INT_ENABLE                  0x01
88 #define BCR_DMA_ENABLE                  0x02
89 #define BCR_RESET             0x80
90 
91 #define BSR                             2         /* read */
92 #define BSR_DMA_ENABLED                 0x80
93 #define BSR_INT_PENDING                 0x40
94 #define BSR_CMD_INPROGRESS    0x20
95 #define BSR_BUSY              0x10
96 #define BSR_SIFR_FULL                   0x08      /* also called STATUS OUT */
97 #define BSR_CIFR_FULL                   0x04
98 #define BSR_TRANSFER_REQ      0x02
99 #define BSR_INTR              0x01
100 
101 #define ISR                             3         /* read, Interrupt Status Register */
102 #define ISR_DEV_SELECT_MASK   0xE0
103 #define ISR_ATTACH_ERR                  0x10
104 #define ISR_INTR_ID_MASK      0x0F
105 #define ISR_COMPLETED                   0x01
106 #define ISR_COMPLETED_WITH_ECC          0x03
107 #define ISR_COMPLETED_RETRIES 0x05
108 #define ISR_PARTIAL_FORMAT    0x06      /* Status available */
109 #define ISR_COMPLETED_WARNING 0x08
110 #define ISR_ABORT_COMPLETED   0x09
111 #define ISR_RESET_COMPLETED   0x0A
112 #define ISR_DATA_TRANSFER_RDY 0x0B      /* No Status Block */
113 #define ISR_CMD_FAILED                  0x0C
114 #define ISR_DMA_ERROR                   0x0D
115 #define ISR_CMD_BLOCK_ERROR   0x0E
116 #define ISR_ATTN_ERROR                  0x0F
117 
118 /* Macros to get info from command status block */
119 #define SB_GET_CMD_STATUS(sb) (((sb)[1] & 0xff00) >> 8)
120 #define SB_RESBLKCNT_IDX      3
121 
122 #define ATN                             3         /* write, Attention register */
123 #define ATN_CMD_REQ           1
124 #define ATN_END_INT           2         /* End of Interrupt (EOI) */
125 #define ATN_ABORT_CMD                   3
126 #define ATN_RESET_ATTACHMENT  4
127 
128 #define DASD_DEVNO_CONTROLLER 7         /* Device number for controller */
129