1# 2# Specific board setup for the Engenius ENH-200 802.11bgn mesh node. 3# 4# The Engenius ENH-200 has the following hardware: 5# 6# + AR7240 CPU SoC 7# + AR9285 Wifi 8# + Integrated switch 9# + 8MB flash 10# + 32MB RAM 11# + uboot environment 12 13#NO_UNIVERSE 14 15include "std.AR724X" 16ident "ENH200" 17hints "ENH200.hints" 18 19options AR71XX_REALMEM=32*1024*1024 20 21options AR71XX_ENV_UBOOT 22 23# For DOS - enable if required 24options MSDOSFS 25 26# uncompress - to boot read-only lzma natively from flash 27device xz 28options GEOM_UZIP 29options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uzip\" 30 31# Used for the static uboot partition map 32device geom_map 33 34# Options needed for the EEPROM based calibration/PCI configuration data. 35options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash 36options ATH_EEPROM_FIRMWARE # Use EEPROM from flash 37device firmware # Used by the above 38 39# Options required for miiproxy and mdiobus 40options ARGE_MDIO # Export an MDIO bus separate from arge 41device miiproxy # MDIO bus <-> MII PHY rendezvous 42 43device etherswitch 44device arswitch 45