1# This file (and the kernel config file accompanying it) are not designed 2# to be used by themselves. Instead, users of this file should create a 3# kernel # config file which includes this file (which gets the basic hints), 4# then override the default options (adding devices as needed) and adding 5# hints as needed (for example, the GPIO and LAN PHY.) 6 7hint.apb.0.at="nexus0" 8hint.apb.0.irq=4 9 10# uart0 11hint.uart.0.at="apb0" 12# see atheros/uart_cpu_ar71xx.c why +3 13hint.uart.0.maddr=0x18020003 14hint.uart.0.msize=0x18 15hint.uart.0.irq=3 16 17#ehci - note the 0x100 offset for the AR913x/AR724x 18hint.ehci.0.at="nexus0" 19hint.ehci.0.maddr=0x1b000100 20hint.ehci.0.msize=0x00ffff00 21hint.ehci.0.irq=1 22 23hint.arge.0.at="nexus0" 24hint.arge.0.maddr=0x19000000 25hint.arge.0.msize=0x1000 26hint.arge.0.irq=2 27 28hint.arge.1.at="nexus0" 29hint.arge.1.maddr=0x1a000000 30hint.arge.1.msize=0x1000 31hint.arge.1.irq=3 32 33# XXX The ath device hangs off of the AHB, rather than the Nexus. 34hint.ath.0.at="nexus0" 35hint.ath.0.maddr=0x180c0000 36hint.ath.0.msize=0x30000 37hint.ath.0.irq=0 38# Set this to define where the ath calibration data 39# should be fetched from in physical memory. 40# hint.ath.0.eepromaddr=0x1fff1000 41 42# SPI flash 43hint.spi.0.at="nexus0" 44hint.spi.0.maddr=0x1f000000 45hint.spi.0.msize=0x10 46 47hint.mx25l.0.at="spibus0" 48hint.mx25l.0.cs=0 49 50# Watchdog 51hint.ar71xx_wdog.0.at="nexus0" 52 53# The GPIO function and pin mask is configured per-board 54hint.gpio.0.at="apb0" 55hint.gpio.0.maddr=0x18040000 56hint.gpio.0.msize=0x1000 57hint.gpio.0.irq=2 58