1 /* 2 * Copyright (c) 2002-2008 Sam Leffler, Errno Consulting 3 * Copyright (c) 2002-2004 Atheros Communications, Inc. 4 * 5 * Permission to use, copy, modify, and/or distribute this software for any 6 * purpose with or without fee is hereby granted, provided that the above 7 * copyright notice and this permission notice appear in all copies. 8 * 9 * THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES 10 * WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF 11 * MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR 12 * ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES 13 * WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN 14 * ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF 15 * OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE. 16 * 17 * $Id: ar5210phy.h,v 1.1.1.1 2008/12/11 04:46:29 alc Exp $ 18 */ 19 #ifndef _DEV_ATH_AR5210PHY_H 20 #define _DEV_ATH_AR5210PHY_H 21 22 /* 23 * Definitions for the PHY on the Atheros AR5210 parts. 24 */ 25 26 /* PHY Registers */ 27 #define AR_PHY_BASE 0x9800 /* PHY register base */ 28 #define AR_PHY(_n) (AR_PHY_BASE + ((_n)<<2)) 29 30 #define AR_PHY_FRCTL 0x9804 /* PHY frame control */ 31 #define AR_PHY_TURBO_MODE 0x00000001 /* PHY turbo mode */ 32 #define AR_PHY_TURBO_SHORT 0x00000002 /* PHY turbo short symbol */ 33 #define AR_PHY_TIMING_ERR 0x01000000 /* Detect PHY timing error */ 34 #define AR_PHY_PARITY_ERR 0x02000000 /* Detect signal parity err */ 35 #define AR_PHY_ILLRATE_ERR 0x04000000 /* Detect PHY illegal rate */ 36 #define AR_PHY_ILLLEN_ERR 0x08000000 /* Detect PHY illegal length */ 37 #define AR_PHY_SERVICE_ERR 0x20000000 /* Detect PHY nonzero service */ 38 #define AR_PHY_TXURN_ERR 0x40000000 /* DetectPHY TX underrun */ 39 #define AR_PHY_FRCTL_BITS \ 40 "\20\1TURBO_MODE\2TURBO_SHORT\30TIMING_ERR\31PARITY_ERR\32ILLRATE_ERR"\ 41 "\33ILLEN_ERR\35SERVICE_ERR\36TXURN_ERR" 42 43 #define AR_PHY_AGC 0x9808 /* PHY AGC command */ 44 #define AR_PHY_AGC_DISABLE 0x08000000 /* Disable PHY AGC */ 45 #define AR_PHY_AGC_BITS "\20\33DISABLE" 46 47 #define AR_PHY_CHIPID 0x9818 /* PHY chip revision */ 48 49 #define AR_PHY_ACTIVE 0x981c /* PHY activation */ 50 #define AR_PHY_ENABLE 0x00000001 /* activate PHY */ 51 #define AR_PHY_DISABLE 0x00000002 /* deactivate PHY */ 52 #define AR_PHY_ACTIVE_BITS "\20\1ENABLE\2DISABLE" 53 54 #define AR_PHY_AGCCTL 0x9860 /* PHY calibration and noise floor */ 55 #define AR_PHY_AGC_CAL 0x00000001 /* PHY internal calibration */ 56 #define AR_PHY_AGC_NF 0x00000002 /* calc PHY noise-floor */ 57 #define AR_PHY_AGCCTL_BITS "\20\1CAL\2NF" 58 59 #endif /* _DEV_ATH_AR5210PHY_H */ 60